Lightronics AS42L User Manual download pdf (Page 2)

Page 2 of 5

AS–42L COMPACT DIMMER

Revision 2.0A OWNERS MANUAL 02/14/2005

www.lightronics.com

Lightronics Inc. 509 Central Drive, Virginia Beach, VA 23454 Tel: 757 486 3588

AS-42L END VIEW

OPERATION

NORMAL MODE (Non-Chaser):

A green LED in the end panel will indicate that a valid LMX-128 control signal is applied to the unit. A DIP switch

block on the end panel selects the starting channel number of the dimmer. The 7 right hand switches control this

function. For example, if all switch positions are down - the dimmer will respond to channels 1-4. Raising the

switch on the far right will set the dimmer to respond to channels 5-8. A complete table of channel assignments

is provided in this manual. You can address up to 512 channels with multiplex control.

RELAY MODE: Pairs of channels (1/2 and/or 3/4) may be switched into the relay mode. In this mode the output

of these channels will be either off or full on depending on the control console channel setting. The trip point for

turn on is aprox. 50%. The 2 left hand switches on the DIP switch block control relay mode channel selection.

The UP position of the switches invokes RELAY MODE.

CHASER MODE:

When operating in the chaser mode the AS-42L becomes independent of the control console and other dimmers.

The green LED indicator is OUT when in the chaser mode. Chaser mode is turned on and off by one of the DIP

switches on the end of the unit. A diagram on the unit cover shows the switch settings for controlling chaser

operation.

Eight different chase patterns are available. A "bounce" condition may be imposed on several of the chase

patterns by setting one of the DIP switches. The bounce condition causes the chase pattern to run in alternating

directions.

The chase step time may be controlled for up to 64 seconds per step. Step fade time is proportional to the step

time. If a channel is in the relay mode during chaser operation, it will “snap” on and off (zero fade time). The

tables below show the details of chaser settings.

1 2 3 4 5 6

No comments

Lightronics AS42L User Manual Page 2